Harrison-labs MIXBUS V2.0.2 Manual de usuario descargar pdf (Pagina 55)

Control Surfaces: Mackie ( OSX / Linux only )

If you are using a Mackie Logic protocol control surface then this should be ON.

Control Surfaces: Generic MIDI ( OSX / Linux only )

If you are using a generic MIDI controller to control Mixbus knobs then this should be ON.

AutoConnect ( OSX / Linux only )

• Auto-connect Inputs to Physical Inputs: When a new track is created, Mixbus will automatically connect the

next available physical input to the track.

• Manually Connect Inputs: When a new track is created, Mixbus will leave the Input un-assigned and the user

must assign it manually before trying to record.

Monitoring

See section 21.0, "Monitoring"

Metering: Fall Off Rate

The decay rate of audio meters, ranging from Off (instant decay) to Slowest (6.6dB/sec decay rate)

Metering: Hold Time

The hold time for the peak-hold indicators. Ranges from Off (no display) to Slowest (5 second hold). Note: This is

only shown in Mixbus for compatibility with Ardour.

Solo

Soloing a track will mute all non-soloed tracks.

• Latched: (default ON) If this is on, then multiple tracks may be soloed at once. If this is OFF, then Soloing a

track will un-solo previously soloed tracks (only one solo allowed at a time).

• Solo In Place: (default ON)

• Solo Via Bus: (default OFF) The Solo signal will appear at the "Control Output", if one is configured (note:

only shown in Mixbus for compatibility with Ardour).

• Show Solo Muting: (default OFF) If this is ON then when a solo is engaged, non-soloed tracks will show a

mute indication.

• Solo Overrides Mute: (default OFF) This allows the track to be heard when soloed, even if the track's Mute is

engaged.

Crossfades

See section 15.0 Editing Tools & Modes for more information about crossfades.

• Crossfades Active: (default ON) This is only provided for compatibility with old sessions. Mixbus no longer

uses separate crossfades.

• Crossfades Auto: (default ON) This is only provided for compatibility with old sessions. Mixbus no longer uses

separate crossfades.

• Use Region Fades: (default ON) If this is off, then region fades will be ignored and all regions will start and

end abruptly.

• Automatic: (default OFF) When 2 regions are overlapped the top region will have a fade in/out assigned that

covers the entire length of the overlap. If you trim a region to create more or less overlap, the fade length will

automatically change to cover the whole overlap.

• Manual: (default ON) Fade lengths don't change when an overlap is created. The user can trim the topmost

region without snapping to the "full crossfade" lengths.

2277..00 OOppttiioonnss MMeennuu

Section 27.0 - Mixbus Options Mixbus User Guide

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 87 88

Sin comentarios

Harrison-labs MIXBUS V2.0.2 Manual de usuario Pagina 55